|
[Sponsors] |
November 8, 2005, 10:24 |
sliding mesh
|
#1 |
Guest
Posts: n/a
|
Dear all,
I am trying to simulate a cross flow fan using the sliding mesh capability of fluent. I am faced with a problem when I set the B.C for the fluid zone arround the rotor. I could give it a sliding mesh with an rpm (same as the rotor) but the fluid motion is in a different center of rotation (an eccentric vortex eye)which I couldn't predetermine. Any one who has an idea please help me. Thank you very much Moke |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 07:20 |
3D Hybrid Mesh Errors | DarrenC | ANSYS Meshing & Geometry | 11 | August 5, 2013 07:42 |
Sliding mesh error | alice | FLUENT | 3 | February 21, 2012 06:53 |
[snappyHexMesh] external flow with snappyHexMesh | chelvistero | OpenFOAM Meshing & Mesh Conversion | 11 | January 15, 2010 20:43 |
dynamic mesh and sliding mesh | nasser | FLUENT | 0 | November 1, 2005 03:37 |