Home > Forums > Software User Forums > ANSYS > FLUENT

how to set two region in Fluent?

Updated Threads

Reply

Search this Thread

November 8, 2005, 12:39	how to set two region in Fluent?	#1
Lu Guest Posts: n/a	A porous region covers the botton of a duct. how to set the region in Fluent? use multiphase model? how to do? Thank you.

November 10, 2005, 14:38	Re: how to set two region in Fluent?	#2
Baicang Guest Posts: n/a	If your problem is two-dimensional,you can set two faces, and then set one of them as porous zone. Define...-> Boundary Conditions...->Fluid... Good luck!

Reply

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to set up a porous region?	famerfamer	STAR-CCM+	4	September 29, 2011 01:50
How do you set up a porous region	charltonjames	STAR-CCM+	13	August 13, 2011 18:29
How to show the transient case?	H.P.LIU	Phoenics	7	July 13, 2010 04:31
How to set environment variables	kanishka	OpenFOAM Installation	1	September 4, 2005 10:15
Level set and Fluent?	markuwill	FLUENT	1	June 3, 2005 12:34

All times are GMT -4. The time now is 13:11.