Home > Forums > Software User Forums > ANSYS > FLUENT

How to modify the pressure swirl atomizer model

Mark Forums Read

Reply

Search this Thread

November 15, 2005, 05:56	How to modify the pressure swirl atomizer model	#1
Giulio Guest Posts: n/a	Hello, I'm studying the injection of water in air using FLUENT. I'm using the pressure-swirl atomizer model. I need to change the value of the spread parameter ( FLUENT doesn't allow to change it, by default its value is 3.5 ), in order to reproduce the experimental droplet size ( DV90, D32 ) - differential injection pressure trend. May anyone give me some advices? Many thanks in advance. Giulio

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Use of k-epsilon and k-omega Models	Jade M	Main CFD Forum	40	January 27, 2023 07:18
"Pressure Inlet" Boundary Setup	Wijaya	FLUENT	15	May 18, 2016 10:08
convergency problem with Solid Pressure Model	commonyue	Main CFD Forum	0	March 30, 2010 05:18
pressure swirl atomizer	saurabh diksht	FLUENT	3	August 23, 2007 08:02
Hydrostatic pressure in 2-phase flow modeling (long)	DS & HB	Main CFD Forum	0	January 8, 2000 15:00

All times are GMT -4. The time now is 06:27.