|
[Sponsors] |
November 24, 2005, 23:01 |
why this type of boubdary conditions work?
|
#1 |
Guest
Posts: n/a
|
have read manual that when we apply mass flow or velocity at inlet and pressure at outlet then it will more robust.but when we apply pressure at inlet and velocity at outlet it will diverge the solution.The later is applicable only to compressible flow.Can anybody tell me why this is happening? the outlet mass flow is applicable to fully developed flow.so what is fully developed flow? and why it is robust for outer mass flow? Thanx
-------------------------------------------------------------------------------- |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Free jet simulation | msarkar | OpenFOAM Running, Solving & CFD | 39 | May 11, 2021 13:21 |
[Commercial meshers] Fluent3DMeshToFoam | simvun | OpenFOAM Meshing & Mesh Conversion | 50 | January 19, 2020 15:33 |
SST SimpleFoam Convergence Problems | camoesas | OpenFOAM | 23 | September 27, 2011 16:27 |
turbulent jet simulation | antonio_ing | OpenFOAM Running, Solving & CFD | 5 | September 16, 2010 02:31 |
LiftDrag tool | nuovodna | OpenFOAM Running, Solving & CFD | 45 | September 2, 2009 17:56 |