 |
 |
 |
|
|
|
[Sponsors] | ||||
December 12, 2005, 12:41
|
Newbie Qn
|
#1 |
|
Guest
Posts: n/a
|
Guys: i ran a case and wrote out the case and dat file for post processing...is it possible for me to run the case from where i stopped if i read back the cae and dat file in fluent?
thanks guys derick |
|
|
||
|
December 12, 2005, 14:18
|
Re: Newbie Qn
|
#2 |
|
Guest
Posts: n/a
|
Yes .. You can.
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Newbie: Install ParaView 3.81 on OF-1.6-ext/OpenSuse 11.2? | lentschi | OpenFOAM Installation | 1 | March 9, 2011 02:32 |
| [GAMBIT] Few newbie questions | ajkratos | ANSYS Meshing & Geometry | 5 | February 28, 2011 22:26 |
| Newbie Questions | pauljwells | OpenFOAM Running, Solving & CFD | 4 | August 31, 2006 17:52 |
| Moving boundary tutorials needed by newbie! | Sebastián Arboleda | CFX | 0 | January 17, 2006 10:05 |
| Newbie questions | Anders Olofsson | Main CFD Forum | 7 | September 1, 2000 16:19 |
Linear Mode
