|
[Sponsors] |
December 13, 2005, 21:28 |
increaseing vol frac after x iterations
|
#1 |
Guest
Posts: n/a
|
hi all
can anyone tell me how do i write the udf for increasing the volume fraction of the dispersed phase after x iterations. i want to increase the volume fraction from 0 to 45% and monitor the pressure to get the phase inversion point.how can one monitor the effective viscosity of the mixture which is greater than mixture viscosity. is there any way of getting the drop distribution and sauter mean dia of the drops.because there is no PBE model in fluent 6.2.... any suggestions are welcome thanks in advance Rashmi |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Extrusion with OpenFoam problem No. Iterations 0 | Lord Kelvin | OpenFOAM Running, Solving & CFD | 8 | March 28, 2016 11:08 |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3 | bookie56 | OpenFOAM Installation | 8 | August 13, 2011 04:03 |
Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 05:24 |
Differences between serial and parallel runs | carsten | OpenFOAM Bugs | 11 | September 12, 2008 11:16 |