|December 16, 2005, 04:00||
I generated a stuctured mesh in PROSTAR but I want to use it in FLUENT, so I exported the mesh from PROSTAR to ICEM first, then export the mesh from ICEM to FLUENT. However when I read the mesh into FLUENT, there is a warning message as follows:
WARNING: cell 19380 of thread 40 has NULL face pointer 5.Error: Build_Grid: grid error.
Clearing partially read grid.
Error: Null Domain Pointer
Error Object: ()
can any one give some ideas? Thanks in advance!
|Thread||Thread Starter||Forum||Replies||Last Post|
|Export 2D mesh from ICEM to Fluent||enghamed||ANSYS Meshing & Geometry||18||August 10, 2015 20:49|
|[ICEM] domain interface in ICEM for fluent||hsn||ANSYS Meshing & Geometry||24||November 27, 2012 17:43|
|Dimension conflict between icem cfd and fluent||highhopes||ANSYS Meshing & Geometry||1||September 9, 2011 11:07|
|Problem with ICEM and Fluent: Automatically created Regions within the domain||sandmike_83||ANSYS Meshing & Geometry||0||September 24, 2010 05:42|
|ICEM 2d mesh to fluent||hsn||CFX||2||June 5, 2008 14:45|