 |
 |
 |
|
|
|
[Sponsors] | ||||
December 16, 2005, 03:00
|
PROSTAR-----ICEM--------FLUENT
|
#1 |
|
Guest
Posts: n/a
|
Hello, everybody!
I generated a stuctured mesh in PROSTAR but I want to use it in FLUENT, so I exported the mesh from PROSTAR to ICEM first, then export the mesh from ICEM to FLUENT. However when I read the mesh into FLUENT, there is a warning message as follows: WARNING: cell 19380 of thread 40 has NULL face pointer 5.Error: Build_Grid: grid error. Clearing partially read grid. Error: Null Domain Pointer Error Object: () can any one give some ideas? Thanks in advance! |
|
|
||
|
December 16, 2005, 03:30
|
Re: PROSTAR-----ICEM--------FLUENT
|
#2 |
|
Guest
Posts: n/a
|
Be sure that you have no trimmmed cells
|
|
|
|
||
|
December 18, 2005, 00:28
|
Re: PROSTAR-----ICEM--------FLUENT
|
#3 |
|
Guest
Posts: n/a
|
you can export the mesh in nastran,then import it use gambit.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Export 2D mesh from ICEM to Fluent | enghamed | ANSYS Meshing & Geometry | 18 | August 10, 2015 20:49 |
| [ICEM] domain interface in ICEM for fluent | hsn | ANSYS Meshing & Geometry | 24 | November 27, 2012 16:43 |
| Dimension conflict between icem cfd and fluent | highhopes | ANSYS Meshing & Geometry | 1 | September 9, 2011 11:07 |
| Problem with ICEM and Fluent: Automatically created Regions within the domain | sandmike_83 | ANSYS Meshing & Geometry | 0 | September 24, 2010 05:42 |
| ICEM 2d mesh to fluent | hsn | CFX | 2 | June 5, 2008 14:45 |
Linear Mode
