Home > Forums > Software User Forums > ANSYS > FLUENT

Multiphase High pressure nozzle analysis

Mark Forums Read

Reply

Search this Thread

December 20, 2005, 01:37	Multiphase High pressure nozzle analysis	#1
Anant Guest Posts: n/a	Hi everybody, I am working on multiphase (air+water) high pressure nozzle analysis (inlet pressure= 3500 psi). I am facing negative pressure (Cavitation) problem. Whenever I switch on cavitation my analysis is diverging. If anybody worked on such type of problems plz tell me how to set proper BCs? Thanks in advance. Anant

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Pressure BC for combustion chamber	Giuki	FLUENT	1	July 19, 2011 11:35
Choked Nozzle : BC using Total Pressure	CSinesi	OpenFOAM Pre-Processing	0	September 1, 2009 06:09
Multicomponent fluid	Andrea	CFX	2	October 11, 2004 05:12
Total Pressure in Laval Nozzle	Sohail Ahmed	Main CFD Forum	0	May 19, 2004 05:43
Hydrostatic pressure in 2-phase flow modeling (long)	DS & HB	Main CFD Forum	0	January 8, 2000 15:00

All times are GMT -4. The time now is 07:21.