 |
 |
 |
|
|
|
[Sponsors] | ||||
December 21, 2005, 23:58
|
INJECTION
|
#1 |
|
Guest
Posts: n/a
|
HELLO
I DOING INJECTIO. I DOING FIRST LAMINAR AND TARBULENT WITH WITH SMALLER HOLE OF 9.525MM DIA FOR FUEL AND 350MM DIA FOR AIR.AIR AND FUEL IS SUPLY AT 0.635M/S AND 0/0975 M/S IN BOUNDARY CONDTION.BOTH LAMINAR AND TARBULENT ARE CONVERGE. IF I WANT TO INJECTION THEN WAHT VELOCITY AND DIA IS GIVEN IN INJECTION SETTING AND WHAT VELOCITY IS GIVEN IN BOUNDARY CONDITION FOR FUEL. THANKING YOU |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| surface injection or point injection? | sukura_1984 | FLUENT | 0 | September 2, 2009 09:26 |
| Urgent help needed with spray injection | nick | Siemens | 14 | June 29, 2008 18:48 |
| On DPM injection properties. | akr | FLUENT | 4 | October 23, 2006 10:54 |
| DPM, UDF, Injection Type | Zhang | FLUENT | 0 | June 8, 2005 15:51 |
| using injection file and parallel process | Cindy Jones | FLUENT | 0 | January 23, 2003 12:40 |
Linear Mode
