Home > Forums > Software User Forums > ANSYS > FLUENT

Help: Initialization of temperature

Mark Forums Read

Reply

Search this Thread

December 21, 2005, 03:52	Help: Initialization of temperature	#1
MANOJKUMAR Guest Posts: n/a	I have constructed a rectangular combustion chamber and i am using the non-premixed combustion using the LDO as the fuel. here i want to know what temperature should i give in the initialization. This temperature should be the flash point of the fuel or any arbitary temperature can be given. thank you.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem with zeroGradient wall BC for temperature - Total temperature loss	cboss	OpenFOAM	12	October 1, 2018 07:36
Calculation of the Governing Equations	Mihail	CFX	7	September 7, 2014 07:27
Bulk temperature Tf is obtained from total or static temperature?	NPU_conanxie	FLUENT	0	March 30, 2011 06:56
temperature initialization	kunal	FLUENT	2	April 13, 2008 05:26
refference & initialization temperature	shanta	Siemens	1	December 10, 2004 14:28

All times are GMT -4. The time now is 02:35.