 |
 |
 |
|
|
|
[Sponsors] | ||||
December 21, 2005, 05:51
|
solid surface's emissivity
|
#1 |
|
Guest
Posts: n/a
|
I have meshed adiacents fluid and solid regions, separates by wall and wall-shadow boundary zones. Where must I specify the solid surface's emissivity? I have seen that there is an "internal emissivity" coefficient" under wall and wall-shadow boundary panel; there is also a "absorption coeffcient" under solid materials panel, but I don't know if these coefficients are these that I'm finding. Thanks
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How model radiation of both solid wall and fluid£¿ | Harry Qiu | FLUENT | 2 | February 4, 2013 00:04 |
| Defining Solid Zones Not working | elmcmaster | FLUENT | 3 | May 22, 2009 08:14 |
| Multiple Solid Domains - Interfaces | Scott | CFX | 8 | July 31, 2008 16:20 |
| solid surface's emissivity | jarno brunetti | FLUENT | 2 | December 23, 2005 05:54 |
| CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 13, 2001 00:19 |
Linear Mode
