|
[Sponsors] |
January 7, 2006, 00:22 |
Setting BC for interior surface
|
#1 |
Guest
Posts: n/a
|
I would like set a specific UDS BC at a specific interface between two regions (interior). Is it possible to do that using DEFINE_PROFILE or DEFINE_ADJUST? Need some advices. Thanks.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cells with t below lower limit | Purushothama | Siemens | 2 | May 31, 2010 21:58 |
Sover setting with TUI | junbbung | FLUENT | 0 | August 20, 2009 00:43 |
LiftDrag utility from v12 to v141 | cfdphil | OpenFOAM Running, Solving & CFD | 2 | December 5, 2007 05:49 |
Ultra high temperature? | bk | Siemens | 2 | July 19, 2005 00:01 |
Warning 097- | AB | Siemens | 6 | November 15, 2004 04:41 |