|
[Sponsors] |
January 8, 2006, 06:41 |
Boundary conditions for VOF Model
|
#1 |
Guest
Posts: n/a
|
Hello,
I am simulating a oil-water stratified flow in a pipe. What boundary condition would be appropriate at outlet if I have constant mass flow of oil and water at the inlet. Also with the mass flow inlet condition, I am not able to define volume fraction for secondary phase (in my case oil), Can that be done or Fluent will take care of it? In the operating conditions panel should I turn on gravity? Thank You in Advance Rizwan |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Spalart-Allmaras model, boundary and initial conditions | vinz | OpenFOAM Running, Solving & CFD | 7 | July 20, 2015 04:57 |
v2-f turbulence model boundary conditions | tstorm | Main CFD Forum | 1 | July 19, 2010 12:15 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
Water vapour condensation in CFX-5.7.1 | hdj | CFX | 1 | November 27, 2005 07:15 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |