 |
 |
 |
|
|
|
[Sponsors] | ||||
January 16, 2006, 05:07
|
XY plotting pressure coefficient on the wall
|
#1 |
|
Guest
Posts: n/a
|
Dear Fluent Users,
I solved the flow around the 2D obstance in Fluent. I used XY plot, Pressure, Pressure Coefficient to obtain distribution of pressure coefficient on the obstacle wall. But the values are overpredicted.I obtained -200 as pressure coefficient. it is not logical. What must I do to obtain logical pressure coef. (between -1<Cp<-2 ) Thanks |
|
|
||
|
January 16, 2006, 21:36
|
Re: XY plotting pressure coefficient on the wall
|
#2 |
|
Guest
Posts: n/a
|
Use proper reference values od area, velocity, etc in the reference values panel.
|
|
|
|
||
|
January 16, 2006, 21:36
|
Re: XY plotting pressure coefficient on the wall
|
#3 |
|
Guest
Posts: n/a
|
Use proper reference values of area, velocity, etc in the reference values panel.
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug | unoder | OpenFOAM Installation | 11 | January 30, 2008 20:30 |
| UDF to monitor minimum pressure on the wall | Arvind Jayaprakash | FLUENT | 0 | September 20, 2007 11:53 |
| Does star cd takes reference pressure? | monica | Siemens | 1 | April 19, 2007 11:26 |
| Gas pressure question | Dan Moskal | Main CFD Forum | 0 | October 24, 2002 22:02 |
| what the result is negatif pressure at inlet | chong chee nan | FLUENT | 0 | December 29, 2001 05:13 |
Linear Mode
