|
[Sponsors] |
January 24, 2006, 09:07 |
Monitor point
|
#1 |
Guest
Posts: n/a
|
Hi,
I want to export Static pressure from an unsteady calculation at different points using the monitor panel. I defined my points, and set static pressure in the surface monitor. But I don't know what to specify in the "report type"? There is several option for a surface, but what happen for a point? I used "sum", "Integral"...for 3 differents point and obtained exactly the same results for all the points.... Any idee? thanks in advance. Frank |
|
January 24, 2006, 18:00 |
Re: Monitor point
|
#2 |
Guest
Posts: n/a
|
You should create a surface point and select a vertex average report type.
thomas |
|
January 25, 2006, 12:22 |
Re: Monitor point
|
#3 |
Guest
Posts: n/a
|
It is exactly what I've done, but results are strange...close data whatever the point location, which is not the case.
Thanks anyway Frank |
|
January 25, 2006, 22:52 |
Re: Monitor point
|
#4 |
Guest
Posts: n/a
|
You can check whether the points are located at the right place using display-contours(unfilled)-surfaces(surface points)
|
|
January 27, 2006, 11:11 |
Re: Monitor point
|
#5 |
Guest
Posts: n/a
|
Use the area weighted average.
|
|
|
|