 |
 |
 |
|
|
|
[Sponsors] | ||||
January 30, 2006, 15:33
|
Reynolds number???
|
#1 |
|
Guest
Posts: n/a
|
I want to simulate a bidimensional laminar flow, with a reynolds number of 300000 and a velocity magnitude of 12m/s, over a flat plate with dimensions 31x4.4m. I have set, in Fluent, density =0.01443064, dynamic viscosity =1.789xe-05 and velocity magnitude =12m/s and, in reference values, a length of 31. It's correct? Or exist another more correct manner to set it?
Thanks to all |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem with decomposePar tool | vinz | OpenFOAM Pre-Processing | 18 | January 26, 2011 02:17 |
| Reynolds Number and Heat transfer Coefficient | panos_metal | FLUENT | 0 | January 7, 2011 06:37 |
| Low Reynolds Number k-epsilon formulation CFX 10.0 | Chris | CFX | 4 | December 7, 2009 23:51 |
| Reynolds Number | Matt | CFX | 0 | February 25, 2009 05:40 |
| [Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
Linear Mode
