 |
 |
 |
|
|
|
[Sponsors] | ||||
February 1, 2006, 04:35
|
Setting a surface roughness on a wall
|
#1 |
|
Guest
Posts: n/a
|
What if modeling a laminar flow airfoil therefore using a laminar model, how do you specify a wall roughness then.
|
|
|
||
|
February 3, 2006, 07:09
|
Re: Setting a surface roughness on a wall
|
#2 |
|
Guest
Posts: n/a
|
in the laminar flow you cannot specify the wall roughness. I tried also very hard. The only solution is to turn on a turbulence model - then is available!
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Surface roughness in Flow-3d | Marco | FLOW-3D | 3 | June 3, 2018 02:15 |
| Surface roughness | alefem | FLOW-3D | 6 | June 3, 2010 12:49 |
| Cells with t below lower limit | Purushothama | Siemens | 2 | May 31, 2010 21:58 |
| wall temperature setting | nianqi | CFX | 0 | October 16, 2006 06:53 |
| CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |
Linear Mode
