CFD Online Discussion Forums

CFD Online Discussion Forums (
-   FLUENT (
-   -   Faces link (

Pamela February 3, 2006 09:38

Faces link
Hi, I'm trying to link two faces for mesh, one over the other, that have 36 holes (the two faces are the upper and bottom sides of the distributor of a hydraulic turbine). I selected the two faces and one edge of each loop but when I apply I receive this message:

error "two faces have inconsistent lower topology".

But there aren't problems in the geometry. Have someone an idea to solve the error? Thanks in advance to everyone

Emanuele February 6, 2006 09:54

Re: Faces link
Problably you have one loop on a face with a different number of edges of the correspondent loop on the other face. Hope this helps

All times are GMT -4. The time now is 10:09.