CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > FLUENT

defining thermal boundary condition???

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   February 15, 2006, 16:50
Default defining thermal boundary condition???
  #1
REZA
Guest
 
Posts: n/a
Hi for the thermal boundary condition of a warm cylinder placed inside the wind tunnel with low thickness which one gives a better results? 1. two walls with the thickness of zero? 2. one wall with an appropriate thickness? in this situation will the mesh change? thanks
  Reply With Quote

Old   February 15, 2006, 22:13
Default Re: defining thermal boundary condition???
  #2
Seyed Farid Hosseinizadeh
Guest
 
Posts: n/a
Hey Man, Could you pleas say what is boundary conditions? I think it's related to your boundary condition. Best Regards, Farid,
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
How to set the Heat Flux boundary condition at Outlet creddy_trddc CFX 3 September 21, 2011 08:44
Concentric tube heat exchanger (Air-Water) Young CFX 5 October 7, 2008 00:17
How to set the boundary condition for thermal analysis sivakumar OpenFOAM Pre-Processing 0 August 20, 2008 07:45
Slip boundary condition what is inside normunds OpenFOAM Running, Solving & CFD 2 June 4, 2007 07:45
Rotating interpolated boundary condition hani OpenFOAM Running, Solving & CFD 0 July 4, 2006 08:09


All times are GMT -4. The time now is 03:50.