CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > FLUENT

Slidng interface help

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   February 19, 2006, 14:25
Default Slidng interface help
  #1
Mike
Guest
 
Posts: n/a
Hi,

Note: zone-surface: cannot create surface from sliding interface zone.

I'm getting the above message when updating a deforming mesh with a sliding zone, when you watch the mesh update, it is stretching one cell on the interface instead of forming new cells to make up the space, I hope this makes sense. I have created the interface from two seperate edges ocupying the same space. Is it obvious where I am going wrong?

Thanks

mike
  Reply With Quote

Old   February 20, 2006, 08:10
Default Re: Slidng interface help
  #2
Mike
Guest
 
Posts: n/a
I have figured out the message, it is the message fluent uses to tell you that the newly created virtual interface walls can't be displayed in the graphical display grid window (i.e. the walls that the manual says it can't display when creating an interface).

Still haven't figured out why it stretches one cell insteady of all of them when deforming the interface zone.

Cheers

Mike
  Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Wind turbine simulation Saturn CFX 45 February 8, 2016 05:42
RPM in Wind Turbine Pankaj CFX 9 November 23, 2009 05:05
CFX Solver Memory Error mike CFX 1 March 19, 2008 08:22
Convective Heat Transfer - Heat Exchanger Mark CFX 6 November 15, 2004 16:55
Replace periodic by inlet-outlet pair lego CFX 3 November 5, 2002 21:09


All times are GMT -4. The time now is 01:09.