CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > FLUENT

Low temperature limit when iterations are done.

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   February 27, 2006, 04:46
Default Low temperature limit when iterations are done.
  #1
MANOJKUMAR
Guest
 
Posts: n/a
Hi I am doing the combustion analysis using the liquid fuel pentane. the fuel temperature is 303K and air temperature is 650 K. After few iteration has occured than the message comes that" temperature limit to 1.0000K in 3cells in Zone 4".Still iterations are going on but how to remove this message.

thanks a lot.
  Reply With Quote

Old   February 27, 2006, 08:35
Default Re: Low temperature limit when iterations are done
  #2
Robin
Guest
 
Posts: n/a
Hi, did anyone reply you with this ? coz i am facing the same problem as you. Do hope to seek help from you if anyone has replied you. thanks lots dude!

Robin
  Reply With Quote

Old   February 28, 2006, 01:08
Default Re: Low temperature limit when iterations are done
  #3
MANOJKUMAR
Guest
 
Posts: n/a
No still no one give ans. if any one give ans i send u. MANOJKUMAR
  Reply With Quote

Old   February 28, 2006, 02:22
Default Re: Low temperature limit when iterations are done
  #4
kiran kumar
Guest
 
Posts: n/a
hi manoj oil droplets absorb energy from surrounding cell and gets evaporated .so that the surrounding cell temperature drastically drops.it will happen to only few cells nothing to worry.If you model droplet evaporation or wet combustion this messages will come. try to limit the temperature to room temp or higher one in the limits panel in fluent solver.

  Reply With Quote

Old   February 28, 2006, 16:30
Default Re: Low temperature limit when iterations are done
  #5
Ahmed
Guest
 
Posts: n/a
This is because the solver has produced temperatures less than 1 K (most probably negative values) and because this is physically impossible (on the absolute scale), the temperature is limited to the minimum value which is 1 k. If the solution is converging then keep it running otherwise you have to reduce the Energy underrelaxation factor.
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
problem with Min/max rho tH3f0rC3 OpenFOAM 8 July 31, 2019 10:48
Velocity blows up suddenly after 30,000+ iterations lordvon OpenFOAM Running, Solving & CFD 15 October 19, 2015 14:52
SLTS+rhoPisoFoam: what is rDeltaT??? nileshjrane OpenFOAM Running, Solving & CFD 4 February 25, 2013 05:13
ForcesCoeffs ronaldo OpenFOAM 4 September 14, 2009 08:11
On the damBreak4phaseFine cases paean OpenFOAM Running, Solving & CFD 0 November 14, 2008 22:14


All times are GMT -4. The time now is 10:53.