Home > Forums > Software User Forums > ANSYS > FLUENT

User Defined Scalar (UDS) question (units)

Mark Forums Read

Reply

Search this Thread

March 1, 2006, 21:04	User Defined Scalar (UDS) question (units)	#1
D Guest Posts: n/a	I'm using a UDS to model diffusivity with the mass flow rate flux function. When entering a value for the boundary value, aka surface concentration (right?) I need to know what units Fluent is expecting? Molarity? g/mL? Thanks!

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
User defined scalar boundary condition	Philip	FLUENT	1	December 4, 2013 11:23
Define bounds of a user defined scalar	Philipp_Sch	Fluent UDF and Scheme Programming	0	October 11, 2010 09:47
solving passive scalar by user function in AVLFIRE	huyp	Main CFD Forum	0	September 4, 2008 11:21
Commercial software question (user viscosity)	Jeff	Main CFD Forum	2	July 20, 2002 11:41
Using user scalar in USRRAT	Jakub	CFX	0	April 25, 2002 14:18

All times are GMT -4. The time now is 02:08.