|
[Sponsors] |
March 2, 2006, 04:07 |
error help
|
#1 |
Guest
Posts: n/a
|
Hey guys,
I'm doing a laminar model for a studying flow in a rectangular tank with slurry flow. I'm using Eulerian multiphase with 3 phases....i have kept no interaction within the phases while iterating it runs for sometime and then shows " "floating point number : invalid number" error can u help me ? |
|
March 2, 2006, 08:53 |
Re: error help
|
#2 |
Guest
Posts: n/a
|
Hi i am not sure but it's possible that it's a graphical error (or a mesh displaying error) i remenber i have this problem when i worked on windows station it was due to graphical card not supported by fluent (i had to desactivate graphical acceleration)
i am not sure that this can help you....it's just an old memory good luck greg (sorry for my poor english) |
|
|
|