Home > Forums > Software User Forums > ANSYS > FLUENT

time step

Mark Forums Read

Reply

Search this Thread

March 19, 2006, 01:20	time step	#1
eddy Guest Posts: n/a	how i setting the time step size? i run simulation for a roots blower with 2000rpm. how i can know the presure and mass flow rate in outlet?

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
HELP! time step too small?	meangreen	Main CFD Forum	6	May 31, 2018 10:41
Superlinear speedup in OpenFOAM 13	msrinath80	OpenFOAM Running, Solving & CFD	18	March 3, 2015 05:36
Hydrostatic Pressure and Gravity	miliante	OpenFOAM Running, Solving & CFD	132	October 7, 2012 22:50
Full pipe 3D using icoFoam	cyberbrain	OpenFOAM	4	March 16, 2011 09:20
calculation diverge after continue to run	zhajingjing	OpenFOAM	0	April 28, 2010 04:35

All times are GMT -4. The time now is 06:15.