How to change levels of display

March 23, 2006, 19:54

Hello everyone, I have a problem...I am modelling open channel flow with air, water and a more dense underlying saline layer with a density difference of 22 kg/m3 between the water and the saline water, and need to know how to change the the levels to display the contors of the mixing of the fluids. As the desity of the air and water differ by so much, Fluent will not display the density difference of the saline to water as it is so small in comparison. Does anyone have any ideas on how to overcome this problem? Thanks for your time. Natalie

March 23, 2006, 21:34

I worked it out, so please ignore this message.

March 23, 2006, 19:54	How to change levels of display	#1
Natalie Guest Posts: n/a	Hello everyone, I have a problem...I am modelling open channel flow with air, water and a more dense underlying saline layer with a density difference of 22 kg/m3 between the water and the saline water, and need to know how to change the the levels to display the contors of the mixing of the fluids. As the desity of the air and water differ by so much, Fluent will not display the density difference of the saline to water as it is so small in comparison. Does anyone have any ideas on how to overcome this problem? Thanks for your time. Natalie

March 23, 2006, 21:34	Re: How to change levels of display	#2
Natalie Guest Posts: n/a	I worked it out, so please ignore this message.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Solid/liquid phase change	fabian_roesler	OpenFOAM	10	December 24, 2012 06:37
Change cell zone index/thread during simulation	neilduffy1024	FLUENT	0	January 17, 2011 09:40
no enthalpy change across the momentum source	Atit Koonsrisuk	CFX	2	December 19, 2005 02:33
free surface display	carno	Siemens	4	October 7, 2005 01:03
Multicomponent fluid	Andrea	CFX	2	October 11, 2004 05:12