Home > Forums > Software User Forums > ANSYS > FLUENT

problem in solving radiation model

Mark Forums Read

Reply

Search this Thread

April 6, 2006, 02:31	problem in solving radiation model	#1
san Guest Posts: n/a	hi, Any of you tried solving the radiation example file? i tried to carry out the same problem, by following the instuction given in it. but i was unable to get the same results as that of the posted results. If you have solution for this problem, please share views on this. with regards san

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Multiple floating objects	CKH	OpenFOAM Running, Solving & CFD	14	February 20, 2019 10:08
Orifice Plate with a fully developed flow - Problems with convergence	jonmec	OpenFOAM Running, Solving & CFD	3	July 28, 2011 06:24
calculation diverge after continue to run	zhajingjing	OpenFOAM	0	April 28, 2010 05:35
MRFSimpleFOAM goes divergenced!	renyun0511	OpenFOAM Running, Solving & CFD	0	November 19, 2009 03:11
Unknown error	sivakumar	OpenFOAM Pre-Processing	9	September 9, 2008 13:53

All times are GMT -4. The time now is 15:54.