 |
 |
 |
|
|
|
[Sponsors] | ||||
April 6, 2006, 03:07
|
Reading geomatry in gambit
|
#1 |
|
Guest
Posts: n/a
|
Hi
when i read a geomatry from gambit , i recieve a message that thread 'a' and 'b' has contigious regions in fluent environment. where i am making mistake. with advance regards Ejaz Ahmed |
|
|
||
|
April 6, 2006, 03:20
|
Re: Reading geomatry in gambit
|
#2 |
|
Guest
Posts: n/a
|
nothing to worry about this message,this is common for many. if your zone contain many discontinuous surfaces you will get this message . you can continue your work by ignoring it.
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| reading gambit mesh files using fortran | zonexo | FLUENT | 4 | December 15, 2020 13:39 |
| [Commercial meshers] Problem converting fluent mesh | vinz | OpenFOAM Meshing & Mesh Conversion | 28 | October 12, 2015 07:37 |
| Problem in running ICEM grid in Openfoam | Tarak | OpenFOAM | 6 | September 9, 2011 18:51 |
| [Commercial meshers] Converting a mesh with splitted cells using fluentMeshToFoam | jlpelerin | OpenFOAM Meshing & Mesh Conversion | 4 | April 25, 2011 17:56 |
| problem when converting mesh (made by ICEM) using fluentMeshToFoam | Forrest_Lei | OpenFOAM | 11 | October 16, 2009 07:28 |
Linear Mode
