|
[Sponsors] |
April 11, 2006, 06:03 |
export in batch mode, programing?
|
#1 |
Guest
Posts: n/a
|
I need to export my calculation properties on lines. Because of the large number of lines it would be the best to write a little program with a loop. What is the easiest way to do this? Should I use the batch mode? I have no experience doing stuff like this with Fluent. Does anybody have an example?
Thanks |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Automatically export all reports in batch | f-w | STAR-CCM+ | 9 | November 17, 2022 05:14 |
Running Ansys in BAtch Mode | kuleuvenstudent | ANSYS | 1 | October 18, 2017 13:11 |
to run a replayfile in batch mode from UNIX | froztbear | ANSYS Meshing & Geometry | 4 | May 13, 2014 09:00 |
OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 20:08 |
How to export residuals plots data in batch mode ? | Anthony Haroutunian | CFX | 1 | March 1, 2007 17:10 |