|
[Sponsors] |
April 11, 2006, 20:46 |
Partial slip wall BC
|
#1 |
Guest
Posts: n/a
|
I am working on simulation of fluidized bed. I need set the partial slip boundary condition for the solid phase on the wall. If I write the UDF to do this, where should I hook the UDF? The 'Specified Shear'? By the way, What's the difference between the specularity coefficient and specified shear? Sorry for such simple questions, thanks in advance.
Tim |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Slip flow boundary condition on wall using UDFs | mahdi haddad | FLUENT | 1 | November 11, 2014 06:13 |
UDF for slip and moving wall | lichun Dong | FLUENT | 3 | March 26, 2014 04:37 |
[blockMesh] StitchMesh on two patches | anita | OpenFOAM Meshing & Mesh Conversion | 31 | April 4, 2013 11:51 |
where to setting the slip wall in udf | cxzhao | FLUENT | 4 | July 4, 2005 02:56 |
natural convection in a square enclosure with a partial dividing wall | sandeep | Main CFD Forum | 0 | April 30, 2000 00:38 |