Home > Forums > Software User Forums > ANSYS > FLUENT

gambit segmentation violation

Mark Forums Read

Reply

Search this Thread

April 13, 2006, 15:11	gambit segmentation violation	#1
vivi Guest Posts: n/a	I installed Gambit in a Linux - Gentoo (64bit) plataform. I cannot import any archives, I cannot mesh any volume, I cannot clean up anything because the following message appears on the Gambit's window and the program closes: "A fatal error has occured. It is not possible for GAMBIT to continue from this point." The following message appears on the konsole: "Received exception: SIGSEGV (segmentation violation)" I had the Gambit installed in a Linux - Red Hat (32bit) plataform, and I didn't have these problems. Any suggestions? Thanks, vivi

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Segmentation Violation	Corentin	FLUENT	1	February 13, 2011 02:07
Gambit Segmentation Fault	bucksfan	ANSYS Meshing & Geometry	7	August 19, 2009 14:15
segmentation violation	wasan	FLUENT	0	December 23, 2008 12:37
Segmentation Violation	Naghman Khan	FLUENT	0	October 1, 2007 07:59
Illegal segmentation error in gambit	Rob	FLUENT	1	February 21, 2005 08:31

All times are GMT -4. The time now is 22:12.