hi all,i'm using a silding mesh for a interior and two interfaces attached to it. their velocity is given in DEFIN_CG_MOTION: vel[1] = u_t1; but they have different velocities each time step. the one command in just a time step Message ("disp = %le, cli = %le\n", u1, cli); actually puts : disp = 3.955120e-008, cli = -1.280314e-003 disp = 1.517457e-007, cli = -1.280314e-003 disp = 5.910051e-007, cli = -1.280314e-003

can anyone help me? thanx in advance sincerely.

please help, i cannot figure out it for several days.

i found that FLUENT accessed the micro DEFINE_CG_ MOTION for 3 times in a sigle tiem step, it's too strange i think.

[mcsagesse]

Hi all I am trying to write UDF for a flow over an oscillating flat plate. I have very very little knowledge of C++ so I am a novice, please I will need assistance from anybody that could help. After going through the Fluent Manual I believe I will need to write DEFINE CG_MOTION udf. Please I need your help. This is my personal email mcsagesse@yahoo.com. My major concern to write the udf for the plate oscillating along the y-axis

Thanks

Wizzy