|
[Sponsors] |
April 24, 2006, 13:03 |
Colanar edges & Vertices: GAMBIT Issue
|
#1 |
Guest
Posts: n/a
|
Hello
I am facing problem in making a face over an airfoil. It is giving me error " the vertices & edges must be coplanar" Can anyone guide me towards the solution. its very URGENT. Regards |
|
April 26, 2006, 05:23 |
Re: Colanar edges & Vertices: GAMBIT Issue
|
#2 |
Guest
Posts: n/a
|
its a difficult error:
For a face, every vertice MUST be in a plane. There is NO distortion allowed. So the sollution: check every vertice and create them again! Sometimes, it is not possible to have them in a plane, so try this: Lets say, you have a square plane, that is distorded around its diagonaly axis (one vertices is outside the plane). Now, simply produce two faces that are triangles, using each 3 vertices (3 vertices are ALLWAYS in a certain plane). Hope, it helps Ralf |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Strange error in Gambit while meshing edges | Ilu | ANSYS Meshing & Geometry | 1 | July 16, 2010 09:17 |
Gambit 2.3.16, Xming or Exceed...HELP! | bambam3417 | FLUENT | 10 | May 7, 2010 13:39 |
Point and click to *add* vertices in Gambit? | AW | FLUENT | 5 | October 5, 2007 14:26 |
Gambit Size functions issue | jon | FLUENT | 1 | December 13, 2006 11:39 |
Gambit IGES import numeration issue | Nicolas Meynet | FLUENT | 1 | October 7, 2006 13:44 |