|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hello, I'm trying to plot the spreading rate of a droplet on a flat surface. One way I could think of, is to plot the location of the interface on the surface (contact line) versus time. But I don't know how to do this. Any suggestion please?
|
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 60 | July 17, 2024 05:45 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug | unoder | OpenFOAM Installation | 11 | January 30, 2008 20:30 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 20:09 |