|
[Sponsors] |
Transient simulation and sliding mesh problems |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 8, 2006, 04:51 |
Transient simulation and sliding mesh problems
|
#1 |
Guest
Posts: n/a
|
Hello! I have two questions about transient simulation and sliding mesh: In Fluent help 26.18.1 , it is said that :" Note that gathering data for time statistics is not meaningful inside a moving cell zone (i.e., a sliding zone in a sliding mesh problem) " but if I want to get the information of some points, which are fixed points in inertial coordinate but in a slinding zone in CFD simulation, how to do with them?
I have tried to write the information (such as pressure velocity) to a file after each time step ,but for about 500 or more points ,this process is very time-consuming especially in fluent's parallel operation. could anybody give some advice? thanks! |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Polyhedra and sliding mesh? | rockewan | FLUENT | 5 | December 1, 2018 20:07 |
Sliding mesh vs MRF in axial turbine simulation | Vito | FLUENT | 3 | December 21, 2011 05:57 |
mesh generation for in-cylinder fluent simulation | hennas | ANSYS Meshing & Geometry | 2 | May 31, 2011 16:08 |
sliding mesh, confused me, help! help! | weiyang1980 | FLUENT | 2 | September 30, 2009 22:45 |
MRF solution data for Sliding mesh simulation | Tantular Nurtono | FLUENT | 4 | March 20, 2006 22:18 |