 |
 |
 |
|
|
|
[Sponsors] | ||||
May 9, 2006, 16:38
|
Top boundary in a entrainment atmospheric BL
|
#1 |
|
Guest
Posts: n/a
|
Dear All,
How can I set a boundary condition on the top of a domain for atmospheric boundary layer which experience a radiative heat transfer (in Fluent)? If I am correct, I need (at the top) a zero gradient for velocities, and a incident solar radiation, which is not readily available in Fluent. Radiation is only allowed in wall (unpermeable, which is not the case, because of boundary layer entrainment), inlet velocity, and others. Which will be the most appropriate BC for my problem, and, if not available in Fluent, how can I implement it? Thanks in advance, Reginaldo |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 60 | July 17, 2024 05:45 |
| inlet velocity boundary condition | murali | CFX | 5 | August 3, 2012 08:56 |
| how to set temperature profile in atmospheric boundary layer | vickrenz | FLUENT | 0 | September 16, 2009 13:26 |
| Maintaining an atmospheric boundary layer | sylvester | OpenFOAM Running, Solving & CFD | 0 | June 4, 2009 04:27 |
| Boundary conditions? | Tom | Main CFD Forum | 0 | November 5, 2002 01:54 |
Linear Mode
