Home > Forums > Software User Forums > ANSYS > FLUENT

Help: about the enhanced wall treatment

Mark Forums Read

Reply

Search this Thread

May 10, 2006, 11:55	Help: about the enhanced wall treatment	#1
maximus Guest Posts: n/a	hi,I am using Fluent to model the impinging jet with roughened wall. I want to use the enhanced wall treatment, but I found there is no roughness option in the BC defininiton panel when I selcet the enhanced wall treatment. So I want to ask if Fluent provides the roughness option when using the enhanced wall treatment. or it needs an additional license to get it work. Anybody has this kind of experience? Please help!! Thanks a lot!! Best Regards! Maximus

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Very technical question about solving wall boundary layer ...	jlb001	FLUENT	6	December 27, 2014 05:56
Near Wall treatment	sven	OpenFOAM	1	September 13, 2009 20:57
Enhanced wall treatment with user-defined mu_t	tstorm	FLUENT	0	August 20, 2009 13:05
LES wall treatment	Valerio	FLUENT	0	April 26, 2008 07:12
help on wall treatment	zwdi	FLUENT	2	December 6, 2004 12:45

All times are GMT -4. The time now is 10:42.