|
[Sponsors] |
May 10, 2006, 19:22 |
Floting point error.
|
#1 |
Guest
Posts: n/a
|
I created a mesh in Gambit and read it in Fluent. When I tried to display the grid it gave me an error messege: 'Floating point error: divide by zero'. I tried to set up the problem in Fluent regardless, but when I tried to solve it gives me the same message. I'm sure there are no problems with the mesh as I have run it with no errors on another machine, I'm assuming that the problem is my with laptop.
I know that this is delt with in the FAQ section but I couldn't find an answer to my question there. It would be greatly appreciated if someone could give me some advice on how to solve this problem. Thanks! |
|
May 10, 2006, 22:52 |
Re: Floting point error.
|
#2 |
Guest
Posts: n/a
|
The error might be caused by ur graph card driver. You can run Fluent by input "fluent 2d -driver msw" in command window.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Compile calcMassFlowC | aurore | OpenFOAM Programming & Development | 13 | March 23, 2018 07:43 |
CGNS Compiling | Diego | Main CFD Forum | 17 | December 21, 2014 01:40 |
UDF: DEFINE_CG_MOTION for vertical jump motion of an electrode! | alban | Fluent UDF and Scheme Programming | 2 | June 8, 2010 18:54 |
Version 15 on Mac OS X | gschaider | OpenFOAM Installation | 113 | December 2, 2009 10:23 |
How to get the max value of the whole field | waynezw0618 | OpenFOAM Running, Solving & CFD | 4 | June 17, 2008 05:07 |