|
[Sponsors] |
May 22, 2006, 06:45 |
Mesh merging
|
#1 |
Guest
Posts: n/a
|
I need to merge 3 meshes in FLUENT using interface boundary conditions. Two meshes have hexahedral cells and the rest one has tetrahedral and prismatic cells. I tried to do this but after mesh check FLUENT told me that there was left-handed faces. I tried to refine mesh near the interface boundaries but left-handed faces didn't disappeared. Have somebody something to suggest me? Thanks.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Number of cells in mesh don't match with size of cellLevel | colinB | OpenFOAM Meshing & Mesh Conversion | 14 | December 12, 2018 08:07 |
[ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
Converting Starccm+ mesh | Ladnam | OpenFOAM | 0 | September 14, 2011 06:30 |
merging two faces without losing mesh | mayur_ | ANSYS Meshing & Geometry | 1 | July 13, 2010 01:10 |