|May 22, 2006, 11:16||
How to add a boundary condition with journal cmds
I've got a basis geometry (geom1) to which I'm adding another geometry, parametrised, with a journal (geom2). Everything's ok but the boundary conditions !
My wall, for example, is composed of 2 parts : edge.1 (geom1) and edge.100 (geom2).
I've already "hand"set the bc in the first geometry (edge.1=cold [name of the wall]), and I would like to add edge.100 in "cold". Hope I'm clear enough !!!
I tried the following command : physics modify "cold" btype "WALL" edge "edge.100" but it erase edge.1 and finaly i've got cold=edge.100 (instead of both !)
Does anybody here knows how to do ?? Thanks !!
|Thread||Thread Starter||Forum||Replies||Last Post|
|Wind turbine simulation||Saturn||CFX||45||February 8, 2016 05:42|
|External Radiation Boundary Condition (Two sided wall), Grid Interface||CFD XUE||FLUENT||0||July 8, 2010 06:49|
|problem with boundary condition???||smn||CFX||5||November 24, 2009 07:37|
|how to set up a wall boundary condition according to calculated wall shear stress?||gameoverli||OpenFOAM Pre-Processing||1||May 21, 2009 08:28|
|Convective Heat Transfer - Heat Exchanger||Mark||CFX||6||November 15, 2004 16:55|