 |
 |
 |
|
|
|
[Sponsors] | ||||
May 31, 2006, 04:13
|
meshing a parasolid import in gambit
|
#1 |
|
Guest
Posts: n/a
|
I am modelling a flow thru a cylindrical reactor. (the reactor consists of a horizontal circular cylinder, which contains again cylindrical inlet and outlet mounted on the circular face of the cylinder. The circular cylinder also consists of 3 baffle plates inside)I drew the geometry in solidworks and imported it into Gambit(bcos of the complex geometry of the baffle plates). As the geometry is very complex, i am a little bit confused from where to start meshing the geometry. Can anybody help me. If u want to see the geometry i can send it.
any sort of help is greatly appreciated, thank you |
|
|
||
|
May 31, 2006, 06:03
|
Re: meshing a parasolid import in gambit
|
#2 |
|
Guest
Posts: n/a
|
hii i am a student @ iitb can u send the geometery to me .. i cud have a look at it
|
|
|
|
||
|
May 31, 2006, 07:02
|
Re: meshing a parasolid import in gambit
|
#3 |
|
Guest
Posts: n/a
|
||
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 05:59 |
| [ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing | David-CFD | ANSYS Meshing & Geometry | 1 | April 1, 2011 05:22 |
| meshing a fan using gambit | tony | FLUENT | 1 | February 15, 2008 00:28 |
| Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug | unoder | OpenFOAM Installation | 11 | January 30, 2008 20:30 |
| Gambit: too long meshing time! | delsolman | FLUENT | 1 | January 29, 2008 19:06 |
Linear Mode
