Mesh error

June 5, 2006, 17:17

Hi,

Can anyone please explain what the following error in GAMBIT means:

Natural source face(s) for projecting volume could not be found.

I run into this error every time I try to mesh my geometry.

Any help is appreciated.

Thanks.

June 6, 2006, 04:34

What Scheme are you using to mesh your geometry? It sounds like you using the cooper method. If so, then you need to specify the end faces as your source faces and the remainder of your faces along the sweep path need to be meshed using the map or sub-map schemes.

Hope this helps

Mark

June 5, 2006, 17:17	Mesh error	#1
Vanessa Guest Posts: n/a	Hi, Can anyone please explain what the following error in GAMBIT means: Natural source face(s) for projecting volume could not be found. I run into this error every time I try to mesh my geometry. Any help is appreciated. Thanks.

June 6, 2006, 04:34	Re: Mesh error	#2
Mark Guest Posts: n/a	What Scheme are you using to mesh your geometry? It sounds like you using the cooper method. If so, then you need to specify the end faces as your source faces and the remainder of your faces along the sweep path need to be meshed using the map or sub-map schemes. Hope this helps Mark

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Building OpenFOAM1.7.0 from source	ata	OpenFOAM Installation	46	March 6, 2022 13:21
c++ libraries and solver compiling	vaina74	OpenFOAM Installation	13	February 3, 2012 17:43
[swak4Foam] groovyBC: problems compiling: "flex: not found" and "undefined reference to ..."	sega	OpenFOAM Community Contributions	12	February 17, 2010 09:30
[Netgen] Installation of Netgen in SuSE Linux 92	edvardsenpriv	OpenFOAM Meshing & Mesh Conversion	23	January 16, 2009 06:12
Problem with compile the setParabolicInlet	ivanyao	OpenFOAM Running, Solving & CFD	6	September 5, 2008 20:50