 |
 |
 |
|
|
|
[Sponsors] | ||||
June 3, 2006, 02:29
|
New to UDF Help really needed
|
#1 |
|
Guest
Posts: n/a
|
Hi All,
I am new to Fluent. I seeking a way to set a volumetric heat source that is changing with time. Also, I am seeking the same for a mass flow inlet. Could any body tell me how to do this from A to Z ??! Cheers, Amr |
|
|
||
|
June 7, 2006, 11:35
|
Re: New to UDF Help really needed
|
#2 |
|
Guest
Posts: n/a
|
Hi
You can go through the UDF manual which is found at the following link. There are some examples similar to your problem. I am sending this thinking that you have an login access to it. If not, give me your e-mail id so that i can send it. http://www.fluentusers.com/fluent/doc/ori/index.htm Hope it helps, Shanti |
|
|
|
||
|
June 8, 2006, 14:27
|
Re: New to UDF Help really needed
|
#3 |
|
Guest
Posts: n/a
|
The manual is good, but also big. I think you can save some time at first by focusing on DEFINE_SOURCE and DEFINE_ADJUST.
Best of luck! -Tom |
|
|
|
||
|
June 9, 2006, 16:43
|
Re: New to UDF Help really needed
|
#4 |
|
Guest
Posts: n/a
|
Hi Shanti,
Unfortunately I don't have access. Please send it to ayelbanhawy@yahoo.com Sorry for my delayed response. Cheers, Amr |
|
|
|
||
|
June 9, 2006, 16:44
|
Re: New to UDF Help really needed
|
#5 |
|
Guest
Posts: n/a
|
Tom, I don't get it. Could you please elaborate.
Amr |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help needed on UDF for modification of default syamlal o' brien drag law | caai9 | Fluent UDF and Scheme Programming | 9 | August 20, 2014 08:52 |
| Help needed with UDF writing (CREATIVITY WELCOME!) | ximik | Fluent UDF and Scheme Programming | 0 | May 13, 2011 12:13 |
| Help needed with UDF writing (CREATIVITY WELCOME!) | ximik | Main CFD Forum | 0 | May 13, 2011 12:11 |
| Parse error in UDF, URGENT HELP NEEDED!!! | Boris Kloser | FLUENT | 2 | December 12, 2009 03:16 |
| Help with UDF for BC needed. | Albert | FLUENT | 1 | January 7, 2004 13:32 |
Linear Mode
