|
[Sponsors] |
June 8, 2006, 04:23 |
long tube mesh
|
#1 |
Guest
Posts: n/a
|
Hi all, Please tell me , what is best method for grid generation in very long tubes? Thank all. Best regards.
|
|
June 8, 2006, 09:13 |
Re: long tube mesh
|
#2 |
Guest
Posts: n/a
|
hi for long tubes mesh generation through gambit would be sufficient . I have meshed tubes having aspect ratios of 100-300 using gambit.Also for mesh generation near the walls you can make the regions finer using ratios or double ratios(if ur are not using symmetry).
regards |
|
June 8, 2006, 12:49 |
long tube mesh
|
#3 |
Guest
Posts: n/a
|
See this web page : http://instruct1.cit.cornell.edu/courses/fluent/
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Negative volume error in hybrid mesh | siw | ANSYS Meshing & Geometry | 4 | September 3, 2014 05:25 |
Mesh motion with Translation & Rotation | Doginal | CFX | 2 | January 12, 2014 06:21 |
3D Hybrid Mesh Errors | DarrenC | ANSYS Meshing & Geometry | 11 | August 5, 2013 06:42 |
[snappyHexMesh] non-smooth mesh | Svensson | OpenFOAM Meshing & Mesh Conversion | 11 | January 18, 2012 09:13 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |