Hi

I want to plot the lift coefficient over a turbine blade surface. I need help on the above matter.

Thanking you

Hi,

You can do as followed:

solve->monitor->force.

Tick "plot" if you want to plot the result during the calculation, tick "write" if you want to save a file.

Be aware of setting the reference values (Report->reference values) otherwise your results will be completely wrong!!

Regards,

Fabrice.

Dear Fabrice

Thanks for you reply.But I don't want to monitor the lift force on the surface.I want to draw a lift coefficient plot from Blade leading edge to trailing edge on pressure surface.

Thanking you