Warning while fluent simulation
hi
while running a FLUENT simulation i am getting the following message: Turbulent viscosity is limited to viscosity ratio of XXXXXX in XX(say 79) cells. And this number is decreasing as the iterations are going forward. what would be the problem. thanks in advance |
Re: Warning while fluent simulation
If the number of the cells are decreasing and the warning disappears it should be no problem. Maybe your initial - conditions were not set good.
|
Re: Warning while fluent simulation
Search this forums for previous threads on the subject.
|
Re: Warning while fluent simulation
thanks for the response.
the warning diminishes as the iteration no. increases, but after some time it reappears with the TURBULENCE VISCOSITY is limited to VISCOSITY RATIO 1.0e+05 in 1 cell. Can this be negligible. thanks in advance |
Re: Warning while fluent simulation
using adaptive meshing divide that cell
|
Re: Warning while fluent simulation
Thanks for the response Rajeev,
As i am new to Fluent how to do this. If u don't mind can explain the procedure. thanks in advance |
Re: Warning while fluent simulation
Go to adaption and mark the cell which is having the high tu viscosity and click adapt. It will ask for hanging node adaption. Click ok and the cell will be divided into 8 in 3d and 4 in 2d. Run for few more iterations and see whether the messages vanish. Generally this happens in regions of high gradient where you have sufficiently large cells which cannot capture the gradient properly. Using adaptive mesh refinements helps in reducing the mesh size in regions of interest. You can look up for the same in the help also.
|
Re: Warning while fluent simulation
thank u rajeev
|
Re: Warning while fluent simulation
Hi Rajeev,
Sorry to bother u again,but how to mark the cell with Turulent viscosity ratio...is it possible to select with the mouse or how... please let me know thanks in advance |
All times are GMT -4. The time now is 20:36. |