adapting mesh in FLUENT

June 21, 2006, 09:02

Hi all

while running the FLUENT simluation i got a warning: "Turbulent Viscosity is limited to Viscosity ratio 1.0e+05 in 3 cells". Is there a possibility to identify these cells and adapt the mesh for these cells. I have been searching for this issue in the USER'S guide, but i didn't find a relevant information. Please let me know your ideas and advices

thanks in advance

June 22, 2006, 15:59

Go to Adapt --> Iso-Value --> Turbulence (from the drop-down menu) --> turb. viscosiy

There you can compute the min- and max-values and select a range. All cells satisfying this condition will be selected.

June 21, 2006, 09:02	adapting mesh in FLUENT	#1
Madhukar Rapka Guest Posts: n/a	Hi all while running the FLUENT simluation i got a warning: "Turbulent Viscosity is limited to Viscosity ratio 1.0e+05 in 3 cells". Is there a possibility to identify these cells and adapt the mesh for these cells. I have been searching for this issue in the USER'S guide, but i didn't find a relevant information. Please let me know your ideas and advices thanks in advance

June 22, 2006, 15:59	Re: adapting mesh in FLUENT	#2
Peter Guest Posts: n/a	Go to Adapt --> Iso-Value --> Turbulence (from the drop-down menu) --> turb. viscosiy There you can compute the min- and max-values and select a range. All cells satisfying this condition will be selected.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Using Surface Mesh from ANSA for Fluent Sim	tommymoose	ANSYS Meshing & Geometry	15	March 3, 2016 17:29
[Commercial meshers] Cannot convert fluent or tgrid hexcore mesh	aerogt3	OpenFOAM Meshing & Mesh Conversion	2	October 22, 2010 11:55
Can anybody tell me what does fluent do using MESH MOTION?	enry	FLUENT	0	October 6, 2010 12:54
Can Fluent handle a degenerate block? Error while reading mesh...	Anorky	FLUENT	1	May 1, 2010 12:47
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 11:55