|June 24, 2006, 17:29||
WhenI try to mesh my geometry according to the heirarchy, I get errors that say:
1. Face 231 has an odd number of nodes on one or more of the faces loops. This may be an outer boundary or around holes in the face.
2. Number of intervals on meshed edges of face 216 does not allow meshing using a scheme of map.
3. Face has less than 3 boundary nodes on one or more face node loops which prevent it from being meshed.
I tried to adjust/ change the interval size several times, but the still the errors continue. Can someone tell me how to get around with these errors?
|Thread||Thread Starter||Forum||Replies||Last Post|
|How to write k and epsilon before the abnormal end||xiuying||OpenFOAM Running, Solving & CFD||8||August 27, 2013 15:33|
|Building OpenFOAM1.7.0 from source||ata||OpenFOAM Installation||42||May 14, 2012 20:48|
|Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3||bookie56||OpenFOAM Installation||8||August 13, 2011 04:03|
|IcoFoam parallel woes||msrinath80||OpenFOAM Running, Solving & CFD||9||July 22, 2007 02:58|
|Could anybody help me see this error and give help||liugx212||OpenFOAM Running, Solving & CFD||3||January 4, 2006 19:07|