Problem regarding interfaces

July 16, 2006, 11:38

Hi

I have defined 2 edges which include the same interface. When i export the file to FLUENT, it separates into 2 different zones. Now, i am not able to define the interface zones with these edges.

Can anyone help me with this? Is there any way to unite these to zones? I have tried to fuse these zones. It says that it cannot be done.

Thanks, Shanti

July 17, 2006, 09:01

When you define interfaces in Gambit, you have to assign different interface boundary conditions for the two sides of the final interface. Then, in FLUENT, you will select "Define interfaces" menu option, and "connect" the two sides.

Razvan

July 16, 2006, 11:38	Problem regarding interfaces	#1
shanti Guest Posts: n/a	Hi I have defined 2 edges which include the same interface. When i export the file to FLUENT, it separates into 2 different zones. Now, i am not able to define the interface zones with these edges. Can anyone help me with this? Is there any way to unite these to zones? I have tried to fuse these zones. It says that it cannot be done. Thanks, Shanti

July 17, 2006, 09:01	Re: Problem regarding interfaces	#2
Razvan Guest Posts: n/a	When you define interfaces in Gambit, you have to assign different interface boundary conditions for the two sides of the final interface. Then, in FLUENT, you will select "Define interfaces" menu option, and "connect" the two sides. Razvan

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
area does not match neighbour by ... % -- possible face ordering problem	St.Pacholak	OpenFOAM	10	February 7, 2024 21:50
conduction problem	venkataramana	OpenFOAM	3	December 1, 2013 07:30
Problem Importing Geometry ProE to CFX	fatb0y	CFX	3	January 14, 2012 19:42
Can I solve this problem by Fluent?	Kai_kc	FLUENT	1	October 27, 2010 05:29
Problem with Domain Interfaces	hagupta	CFX	13	May 5, 2006 12:41