|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
I have a converged case of a burner. I wrote the interpolation data of the temperature for all fluid zones into a IP file. For another case I'd like to have calculated, I tried to "interpolate - read and interpolate" the saved data. But when I look at the temperature afterwards, I always get the same temperature as before and not those from the converged case. The IP file looks ok though (temperatures written are those of the converged case). What am I doing wrong?
|
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
Perhaps first initialize your Solution and then interpolate your data
cheers Cairol |
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
conduction problem | venkataramana | OpenFOAM | 3 | December 1, 2013 08:30 |
Problem Importing Geometry ProE to CFX | fatb0y | CFX | 3 | January 14, 2012 20:42 |
area does not match neighbour by ... % -- possible face ordering problem | St.Pacholak | OpenFOAM | 9 | November 22, 2011 11:02 |
Value below interpolation range | Clif | CFX | 0 | December 19, 2010 10:53 |
Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 15:52 |